| Author | Message | ||
| Kenneth |
Hi I�ve read a lot of the posts regarding correct impedance, but i�m still a little confused regarding the right setting for my amp. I have a music man 212 65 combo and have just replaced the speakers with 2 8 ohms eminence. i only use the internal speakers, there is no extra cabinets attached. is it correct that my speakers are wired in parallel and therefore i should use the 4 ohm setting? Kind regards Kenneth | ||
| Steve Kennedy (admin) |
The original 8-ohm speakers from the factory were wired in parallel and the amp was set for 4-ohms when using only the internal speakers. If you didn't change the speaker wiring when you replaced the speakers, this should still be the case. Steve | ||
| Kenneth |
Thanks Steve for the fast respond.. I�ve connected them the same way as they were before . and it was the original speakers I replaced and I suppose they haven�t been rewired. I�ll go with the 4 ohm setting then. Thanks again  Kenneth |
Tue, 03/25/2014 - 10:00
#1